The MB102 bread board, with two way independent control, The board can be switch between 0V, 3.3V, 5V. On-board there are two sets of 3.3V, 5V DC output pins, Please Change the jumper cap position to select 5.0V or 3.3V Voltage.

Fits RG58U / LMR 195 and other similar cable sizes, This is the most simplest way of fitting PL259 s to Coaxial Cable!!! UHF connectors are generally usable through what is now known as the VHF and HF frequencies Simply cut back outer Coax insulation - Fold Back Braid - Remove inner conductor Insul...

UHF male solder PL259 connectors with silver plated body, pin, and sleeve. Dielectric is Teflon to handle higher power and withstand high temperature. The connector works great for RG-8, 9, 213, 214, and L400 cable. Could be used with a reducer to build cables with smaller sizes such as RG-58, 59, a...

Very easy to use power supply board for use with the MB102 Breadboards. You have two separate power supplies 3.3v or 5v. You can have two different voltages or both can be set the same. The voltage outputs are set by jumpers on each output. The board can be powered from a wall wort power supply 6.5-...

BNC female with nut bulkhead handle solder connector, here 5 pieces included.

Lsgoodcare 3.5MM 1/8 Inch Female Plating Stereo Jack Panel Mount Solder Connector Terminals Great for Audio Earphone and Other Need 3.5MM Jacks DIY Projects, Pack of 10 3.5MM (1/8"), 3-Conductor Stereo Panel Mount Jacks with Solder Terminals Mounts in 1/4 Inch Hole Durable Metal Accessories Are Ma...

Brand new UHF female jack 4-hole chassis panel mount with a solder cup contact. SO-239

UHF SO-239 female jack, 4 hole panel mounting. Used widely for radios, public address system, audio, video, mobile radio and test equipments.

The Hakko 599B-02 is a replacement solder tip cleaning wire sponge. These sponges are hard enough to remove debris and some corrosion from the solder tips while being soft enough not to damage the tip. They help to remove oxides and excess solder to preserve tip life and enable clean, precise solder...

This petroleum/rosin contains NO Zinc Chloride or Ammonium Chloride, making it a better choice for electronic repairs. Rosin leaves a protective coating over soldered area once job is finished