The PDB300 is a high-current power distribution block designed to connect up to 3 car amplifiers. It has 1 input and 3 outputs for power or ground wire connections. The main input lets you connect 4 or 1/0-gauge wire and the 3 outputs allow for 4 or 8-gauge wire. It can also be used to combine the g...

Lanzar Model : VCT26106000 Watt 2 Channel High Power MOSFET Amplifier 3000W x 2 Output at 4 Ohms6000W x 1 Bridged Output at 2 Ohms2 Ohm StableMOSFET Power SupplyVariable Hi-Pass : 40 Hz-250 HzVariable Low-Pass : 40 Hz-250 HzVariable Input Level (Gain) Control : 6V-200mVVariable Bass Boost : 0-18dBVa...

The KCA Kable (Kolossus Copper Aluminum) is the next generation of our Copper Clad Aluminum (CCA) power and ground cables. The new KCA 4 Gauge uses 29. 44mm^2 of Copper Clad Aluminum (CCA) to transfer current from your battery to amplifier. Copper Clad Aluminum (CCA) is made up of 90% Aluminum and 1...

Remote Level Control offers remote level control of the amplifier. Once the on-board gain control is set, the PLC2 can attenuate (and not increase) the level from that point. Cable and mounting hardware included. For use with select 2013 and newer PUNCH and POWER amplifiers. The PLC2 is compatible w...

Features & Benefits Recharges 1 to 4 pieces of AAA, AA, C, D or 1-2 pieces of 9V Ni-MH batteries Recharges batteries in single or group Automatic charging current selection for different sizes of batteries Built-in IC timer control LED lamp to indicate proper charging Fast charging in the specified...

The La Crosse Technology BC700 Alpha Power Battery Charger has four modes and charges all NiCd and NiMH AA and AAA rechargeable batteries. The four modes include charge, discharge (discharges the batteries and then recharges them), recharge (discharges and recharges up to 20 times to bring old batte...

The AE100VC features high quality audio transformers, removable solderless connection terminals and a computer grade double-sided glass-epoxy printed circuit board. An impedance matching switch multiplies the impedance the amplifier "sees" by two, four or eight times, allowing parallel connection of...

Promariner ProSport 20+ Generation 3 Heavy-Duty Recreational Series On-Board Marine Battery Charger. 20 Amp capacity, 12/24/36 Volt output, 3 Banks. ProSport Generation Chargers incorporate all-digital microprocessor control. The new ProSport Series provides automatic installation feedback with its...

Designed for whole house audio systems, OSD Audio’s VMS100 is a heavy-duty yet decorative impedance-matching volume control that is ideal for adjusting the volume of a pair of speakers independently in various rooms of your whole house audio system. Rated at 100 Watts peak with minimal bass roll-off...

Características e especificações:8-Channel Classe D Marine Full-Range AmplificadorRMS Potência nominal @ 14,4 V:4 ohms: 75 watts x 8 canais.2 ohms: 100 watts x 8 canais.Bridged, 4 ohms: 200 watts x 4 chan.RMS Potência nominal @ 12,5 V:4 ohms: 60 watts x 8 canais.2 ohms: 90 watts x 8 canais.Bridged,...

Gimbal knobs.GK-9Works with: Cuda 168 EX, FishEasy 250 DS, FishElite 320, FishElite 480, FishElite 500C, FishElite 502C iGPS, FishElite 640C, FishElite 642C iGPS, FishMark 160, FishMark 240, FishMark 320, FishMark 480, FishMark 500C, FishMark 640C, FishStrike 1000C, FishStrike 2000C, GlobalMap 2400,...

Pyramid Model : RSW1810018 Gauge 100 ft. Spool of High Quality Speaker Zip Wire 18 Gauge 100 ft. Spool of High Quality Speaker Zip WirePyramid offers a new line of speaker wires in its finest to accommodate DIY stereo to amplifier installation needs. It is 18-gauge to offer just enough resistance an...